This master of science thesis is focusing on how the fault handling on hardware connected toa control unit on a Scania vehicle is working. To the hardware counts buttons levers, sensorsand CAN. The work has been concentrated upon how the fault handling is working and if it ispossible to find any new fault modes.The control unit that has been studied is called the Coordinator and is the core in Scanias threenetworks of control units. The Coordinators work is to transmit messages between the threenetworks and to process signals from buttons, levers and sensors. The values is then usedinternally or is sent to other control units on the CAN networks.

Tomo Hugglink (TOMO Skog) is an innovation for harvest and transport of biofuels. The system consists of a truck, a chipping unit and crane mounted on a link and a wood chip trailer. The system works in such a way that the chipping unit is disconnected and placed on the site and wood chips are loaded directly into the wood chip trailer.The aim of this study was:- To examine the performance of the TOMO Hugglink system under different conditions such as the size, placement and quality of the pile.- To calculate the cost per raw ton for two vehicle combinations at different transport distances and to examine the effect of a reduction in set-up time and an increase in load weight.- To identify possible improvements with the TOMO Hugglink system.A time study was conducted within the thesis work to make it possible to determine production and time consumption. In the subsequent economic analysis the cost per tone at different transport distances was calculated for two different lorry concepts. Furthermore the effect of a reduction in set-up time and an increase in load weight was calculated.Under current conditions the utilization of the chipper is low and only 29 % of the total system time is occupied by chipping.

This report is a Master?s Thesis performed by Andreas Adolfsson and David Jacobsson atChalmers University of Technology. The purpose of this master?s thesis is to evaluate anew method for load-shedding, the voltage controlled underfrequency load-sheddingdeveloped by ABB. This report presents a comparison between conventionalunderfrequency load-shedding and this new method for load-shedding.

The aim of this study is to evaluate whether the value of occupant load is over or under estimated when the Swedish general value for department stores, 0,5 person/m2, is used for dimensioning shopping centers. The data that was analyzed derives from seven shopping centers and one department store. A conservative method was used to calculate the occupant load factor. The analysis shows that two groups can be discerned: one group that is characterized by a lower occupant load factor that does not exceed 0,3 person/m2, and one group with a higher occupant load factor. Shopping centers with a higher occupant load factor are located centrally in large urban areas.

Combustion of fossil fuels is today the dominating source of energy. During combustion,carbon dioxide is formed. The carbon dioxide accumulates in the atmosphere,which raises the global average temperature on earth through the so called greenhouseeffect. The only way to reduce the emissions of carbon dioxide from combustionin a coal fired power plant is through carbon capture and storage (CCS).Post-combustion capture is a technology to separate carbon dioxide from the uegas after the combustion for efficient transport and storage. The steady state operationof coal fired power plants with post combustion capture has already beenthoroughly investigated on a pilot scale, however much work remains to investigatethe plants dynamic operation.

The application of the LSS law and how the public organization (Municipality of Hudiksvall) later had to reform their organization to fit the new demands is the foundation to this master's thesis. An internal evaluation was performed due to this reorganisation process within the social care department (LSS unit). The aim was to investigate and evaluate if the reorganization resulted in a better working environment and if the work load (distribution of work) became more evenly divided between the different unit managing directors. The primary empirical information to this master's thesis is collected from that evaluation report. The main aim of this master?s thesis is to answer if the organisational choice between specialised or de-specialised working tasks has an effect (experienced and measured) on the level of stress among the unit managing directors.

Kitron had wishes to be able to test and measure how disturbance affects their vehicle electronic units before they have been verified by SP Technical Research Institute of Sweden in Borås. This work started with the writing of a demand specification together with Kitron for a product PSQS, Power Supply Quality Simulator, which can generate some test pulses according to a standard for electronic units to Volvos vehicles. A design proposal was developed with the help the demand specification and was verified with the help of simulations. All electric schematics was designed with the guide of the design proposal. The pulses realized in the works of this thesis are those which Kitron experienced that they have a need to test in their own premises and which are possible to generate with the means available.

This thesis has been done on a haulage contractor company named GP-Last (AB Gustav Perssons Åkeri) and the purpose with the paper was to analyse their traffic from Malmö to Stockholm and leave suggestions on efforts that GP-Last can use to increase their level of transportation quality. This has been done with two main questions, which problem do they have today and which efforts they need to do to solve their problems? Through a case study with interviews as method to collect data it showed that GP-Last had four main problems.        Not enough information about their freights. The transport planning unit in Malmö doesn?t have the exact delivery address when GP-Last begins to bring in the gods.        There are no clear routes.

The report is part of the university´engineer program within Industrial Organization and Economics with specialization in Logistics and Managment at Jönköping´s university.Skoghall´s mill underlies a large supply chain, which means there should be a lot of areas in need of small improvement measures. This report illustrates a small part of one of these areas and is focused on the loading distribution services in the terminal Vänern.At the moment there´s a very unequal load of the load carriers SECU box and Container at the terminal. Skoghall´s mill has the desire to equalize the high and low load levels of the 2 loading carriers named previously. One of the options to solve the problem is to set a limit of how much the carriers can load per week or per day. The mill also wants it to be investigated if the proposition would influence the customers in any way and if both the company and its customers could handle a lower level of delivery services in case the proposition was to be applied.The goal to be achieved with this thesis is to provide balance to the unequall loading of the 2 load carriers, SECU and Container, and investigate whether or not the Skoghall´s mill´s customers, could manage the lower degree of delivery service that the proposition would imply.For this goal to be achieved, random sample investigations were taken from orders of a customer that is provided with SECU load carriers and the same was made with a Container´s customer.

The market-leading wage and PA-.system for the Swedish public sector Palasso is developed in Karlstad. In order to achieve the highest quality of code , the developing team behind Palasso has been conducting extensive testing. Testing is done to ensure that the software does what it should do. However, the testing has been done at a high level. In order to continue to evolve, the group that develops Palasso has started to look at the new development methods that have become popular in the computer industry in recent years.

On some occasions it may be inappropriate with a cameraman behind the camera. In somecases there is no cameraman available or it is a smaller event, like a family celebration, to befilmed. It can also be difficult for a cameraman to shoot from certain angles. One solution forthis kind of situations can be to remotely control the camera movements. There are thosekinds of solutions on the market today but they either address professional filmmakers or thefunctionality is limited, for example by the absence of wireless remote control.This project aims to develop a solution to the problem with absence of wireless remote controland also a solution with more flexibility and less complexity than today?s solutions.

Syftet med denna undersökning har varit att underlätta för företaget Re-Load att presentera sin lastpall som produkt för potentiella kunder. Syftet har också varit att stötta Re-Load till att bli licenserad EUR-pall samt att successivt ersätta befintliga lastpallar och långsiktigt exekvera företagets affärsplan. Målet har varit att undersöka produkten avseende lönsamhet, miljöinverkan och hur den påverkade arbetsmiljön. Under-sökningen har genomförts med ett befintligt flöde där produkten använts och utifrån detta kunde en flödesstudie samt en komparativ produktstudie utföras med en alternativ lastpall. Med data hämtat ur detta flöde utfördes en investeringskalkylering, miljöberäkningar, subjektiva intervjuer samt dokumentation.

 Our study aims at investigating the unit manager?s, within LSS, perceiveddiscretion, when people with Down´s syndrome develop Alzheimer?s disease. We wanted to know what they perceive as limiting factors or facilitators in order to meet changing and/or emerging needs, as well as how they interpret their discretion in relation to this. We have conducted semi-structured qualitative interviews with five unit mangers within LSS.When analyzing the interview material, we have used a theoretical approach from a street-level bureaucracy and from the unit managers? perceiveddiscretion point of view.Our study?s result demonstrate that the unit managers are experiencing a wide discretion and do not feel a need to widen their identifieddiscretion..

The task in this master thesis was to design and construct a prototype of a satellite antenna driver unit. The unit is to be robust and work in cold weather down to -40°C, so that it can be mounted on the roof of a minibus. A microcontroller controls the H-bridges simultaneous, each connected to an electrical motor. Hardware and software protections were implemented to ensure that the antenna can not turn outside its allowed area and risk breaking. The unit can output voltages at many different levels and communicate at a multitude of signal standards..

The purpose of this study has been to examine the unit manager?s perspective on making Lex Sarah-notifications. The study has been carries out by six semi structured interviews with persons in leading positions of the elderly from three different municipalities. They were asked about different circumstances that affects the problems with Lex Sarah. The results indicates that the unit manager?s act on elder abuse from the complex mechanisms that exist within the organization.